Description
The new GKTECH Super Lock front lower arms are a drifters wet dream but are equally as impressive for our grip friends with 1.37″ (35mm) of length adjustment. For drifters (aka skid racers) these lower arms will support 70 degrees of steering lock lead wheel and 65 degrees trailing wheel. They may look similar to others currently sold by other companies but are in fact unlike any other lower arms on the market. These are the first commercially available 1 piece lower arms that work with OEM and OEM style front knuckles (such as the drop knuckles that we sell).
These lower arms are based off CMM data, are CAD designed, FEA tested, have CNC machined ends and the main body is CNC Machined chromoly steel for maximum strength. To finish the arms off they’re E-coated (aka electrophoresis coating) for rust prevention and we’re exclusively using Teflon lined bearings including a large 3/4″ outer high misalignment bearing, all with dust covers for increased longevity.
– Feature 5/8″ Teflon lined sphericals (inner) and high mis-alignment 3/4 sphericals (outer) which eliminates the flex found in factory rubber bushing offering a more direct and predictable feel.
– Our V2 lower arm main body is CNC machined from a billet chromoly block with CNC machined ends.
– CMM measured, CAD designed, FEA tested and CNC machined.
– Choose from either S13/R32/Z32 tapered shank or S14/S15/R33/R34 tapered shank at the time of ordering
– Choose between 2 different ball joint shank lengths; standard or +0.78″ (20mm) to help with roll center correction.
NOTE: RC is only corrected on S-chassis’, do not buy the +0.78″ (20mm) shanks for use on Skylines.
NOTE#2: The +0.78 (20mm) shank with use of non RC corrected knuckles leaves very little clearance from the rotor to ball joint housing. This will be an issue in some setups when running near 0 camber.
Length Options:
– S13/R32/Z32 adjustable from +0.35” (9mm) through to +1.73” (44mm)
– S13/R32/Z32 adjustable from +1.53” (39mm) through to +2.91”(74mm)
– S14/S15/R33/R34 adjustable from OEM length through to +1.37” (35mm)
– S14/S15/R33/R34 adjustable from +1.18” (30mm) through to +2.55” (65mm)
Shank Options
– S13 standard length
– S13 +0.78 (20mm) + $4
– S14/S15 standard length
– S14/S15 +0.78″ (20mm) + $4
<b>NOTE: +0.78 (20mm) extended shank is not recommended for rims smaller than 18″ in diameter and only needed on an S-chassis that is REALLY low.</b>
Vehicle Compatibility:
– Nissan 240sx
– Nissan S13 Silvia
– Nissan S14 240SX
– Nissan S15 240SX
– Nissan Skyline R32 GTS-T
– Nissan Skyline R33 GTS-T
– Nissan Skyline R34 GTT
– Nissan C33
– Nissan C34
– Nissan C35
– Nissan A31 Cefiro
– Nissan Z32 300zx
NOTE: Can be used with all OEM style front knuckles or cut and shut knuckles.
NOTE#2: On R32/R33/R34 Skylines the LCA’s can only be run with the use of an S chassis swaybar setup (D bushes/mount, end links and bar)
Clearance Vs straight OEM style tension rods:
Reviews
There are no reviews yet.